8. 150 FourStroke and DTS models ‑ Turn the ignition key to the "START"
position and release the key. The electronic starting system will
automatically crank the engine for starting. If the engine fails to start, the
engine will stop cranking. Turn the key to the "START" position again until
the engine starts.
9. After the engine starts, check for a steady stream of water flowing out of
the water pump indicator hole.
IMPORTANT: If no water is coming out of the water pump indicator hole, stop
the engine and check the cooling water intake for obstruction. No obstruction
may indicate a water pump failure or blockage in the cooling system. These
conditions will cause the engine to overheat. Have the outboard checked by
your dealer. Operating the engine while overheated will cause engine damage.
WARMING UP ENGINE
Before beginning operation, allow the engine to warm up at idling speed for
three minutes.
Stopping the Engine
Reduce the engine speed and shift the outboard to neutral position. Turn the
ignition key to "OFF" position.
To Next Page
Loading...
Need help?
General
