Mercury Jet 65 - Clearing A Lodged Impeller; Engine Break-in Procedure

OPERATIONS
32
ob00348
3. Squeeze the fuel line primer bulb several times until it feels firm.
ob00349
NOTE: The engine will not start unless the lanyard is set to the "RUN" position.
4. Set the lanyard stop switch to the "RUN" position. Refer to General Information - Lanyard Stop Switch.
ob00350
5. Shift outboard to neutral (N) position.
N
ob00351
N
ob01446
6. Models without power trim - Position tilt lock lever to the lock position.
ob00352
7. Tiller handle models - Align the throttle grip pointer to the "START" position.
ob01677