Mercury Jet 65 - Impeller Removal and Installation

MAINTENANCE
46
Impeller Removal and Installation
!
WARNING
If the driveshaft is rotated while the engine is in gear, there is the possibility that the engine will crank over and
start. To prevent this type of accidental engine starting and possible serious injury caused from being struck by
a rotating impeller, always shift outboard to neutral position and remove spark plug leads when servicing the
propeller.
REMOVAL
1. Shift outboard to neutral (N) position.
N
ob00351
2. Remove spark plug leads to prevent engine from starting.
ob00375
3. Remove the water intake housing that is fastened with six screws.
ob01411
4. Straighten the bent tabs on the impeller nut retainer and remove the impeller nut.