MIE MODELS - VELVET DRIVE TRANSMISSION
SERVICE MANUAL NUMBER 23
90-861326--1 MARCH 1999 Page 2C-17
Shift Cable Installation And Adjustment
IMPORTANT: When installing shift cables, be sure that cables are routed in such a
way as to avoid contact with moving parts and/or sharp bends [all bends must make
greater than an 8 inch (203 mm) radius]. DO NOT fasten any items to shift cables.
Shift cable must be hooked up to remote control before starting installation and adjustment
procedures. Refer to “Propeller Rotation,” in SECTION 8C for transmission shift lever direc-
tion of movement versus propeller shaft output direction of rotation.
Velvet Drive Transmissions
IN-LINE AND REMOTE V-DRIVE
IMPORTANT: Velvet Drive Transmission Warranty is jeopardized if the shift lever
poppet ball or spring is permanently removed, if the shift lever is repositioned or
changed in any manner or if remote control and cable do not position shift lever
correctly.
22457
F
R
a
b
c
d
e
F
NR
–
–
Forward Gear Shown
a-Transmission Shift Lever
b-Shift Lever MUST BE Over This Letter When Propelling Boat FORWARD
c-Shift Lever MUST BE Over This Letter When Propelling Boat IN REVERSE
d-Poppet Ball MUST BE Centered in Detent Hole For Each F-N-R Position
e-Install Shift Lever Stud In This Hole, If Necessary, To Center Poppet Ball in
Forward And Reverse Detent Holes
1. Verify shift cable stud is in appropriate stud hole as indicated. Tighten elastic stop nut
securely.
50947
a
a-Anchor Stud Hole
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General