SERVICE MANUAL NUMBER 23
TROUBLE CODE DIAGNOSTICS - 454/502 MAG MPI & 8.2L MPI
90-861326--1 MARCH 1999 Page 5F-29
Code 33 (2 of 3): Manifold Absolute Pressure (MAP) Sensor Circuit (Scan)
TEST DESCRIPTION:
Number(s) below refer to step number(s) on the diagnostic table.
Step 4. Engine misfire or a low, unstable idle may set Code 33. Disconnect MAP sensor and
system will go into backup mode. If the misfire or idle condition remains, refer to “Trouble-
shooting.”
Step 5. If the ECM recognizes the low MAP signal, the ECM and wiring are OK.
NOTE: If engine is idling rough, unstable or incorrect, this condition must be corrected be-
fore proceeding (refer to troubleshooting section).
STEP ACTION VALUE YES NO
PROCEED TO
1
Was the “On-Board Diagnostic” (OBD) System
Check Performed?
– Step 2
Go to
OBD
System
Check
2 Engine idling
Does scan tool display a MAP sensor volt-
age of less
than 1 volt?
– Step 4 Step 3
Does scan tool display a MAP sensor volt-
age of greater
than 4 volts?
– Step 5 Step 3
3
Code 33 is intermittent, if not additional codes
were stored, refer to “Diagnostic Aids” on fac-
ing page.
– – –
4 1. Ignition OFF.
2. Disconnect MAP sensor electrical con-
nector.
3. Jumper MAP sensor harness terminals
“B” and “C” together.
4. Start engine.
Does scan tool display a MAP sensor volt-
age of greater
than 4 volts?
– Step 9 Step 6
5 1. Ignition OFF.
2. Disconnect MAP sensor electrical con-
nector.
3. Start engine.
Does scan tool display a MAP sensor volt-
age of less
than 1 volt?
– Step 7 Step 8
6 1. Ignition OFF.
2. Connect DVOM between MAP sensor
harness terminal “C” and “A.”
3. Ignition ON.
I
s voltage over 4 volts?
– Step 11 Step 10
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General