VELVET DRIVE 5000V V-DRIVE TRANSMISSION SERVICE MANUAL NUMBER 23
Page 8C-6 90-861326--1 MARCH 1999
IMPORTANT: Be certain anchor stud is installed in the front hole as shown in the illus-
tration following.
73284
a
b
a-Anchor Stud In Front Hole
b-Shift Cable Bracket
Remote control must provide a total shift cable travel (at transmission end) of at least 2-3/4
in. (70 mm). This is necessary to position transmission shift lever fully in the forward and
reverse gear positions. Insufficient shift cable travel will cause transmission to slip and even-
tually fail.
72602
a
a-2-3/4 In. (70 mm) Minimum
IMPORTANT: The distance between studs (Dimension C) shown in the following illus-
tration is set at 7-1/8 in. (318 mm).
73284
b
b
d
c
a
a-Shift Lever
b-Anchor Stud
c-Dimension Between Studs - 7-1/8 Inch (318 mm)
d-Shift Lever Bracket
IMPORTANT: When installing shift cables, be sure that cables are routed in such a
way as to avoid sharp bends and/or contact with moving parts. DO NOT fasten any
items to shift cables.
8. Place remote control shift lever and transmission shift lever in neutral position.
9. Remove nuts and washers from shift cable attaching studs.
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General