6. Range: The estimated range is based on boat speed, fuel
consumption and fuel remaining in the tank. The numbers
displayed indicates an estimate of the distance you can travel
with the remaining fuel. Speed input required (Paddle Wheel,
Pitot Pressure or GPS).
7. Fuel Economy: Displays the average "AVG" fuel
consumption as well as Instantaneous "INST" fuel economy.
The numbers displayed indicate miles per gallon "MPG" or
kilometers per liter "KM/L". Fuel Reset: To reset, select the
display screen and press "MODE" and "-" simultaneously.
8. Trip Odometer: Displays the distance traveled since the
gauge was last reset to zero. Trip Reset: To reset, select the
display screen and press "MODE" and "-" simultaneously
9. Digital Speedometer: Displays the boat speed in miles per
hour, kilometer per hour, or nautical miles per hour. The
speedometer will use the paddle wheel for its low speed
readings but will switch to the speedo or GPS (if connected)
for high speed readings. (Transition point setting is described
in Cal2).
10.Steering Angle: Displays the relative position of the steering
system. Available on Mercury MerCruiser models only. A
steering angle sensor must be installed on the engine.
To Next Page
Loading...
