When the ignition is turned on, the tachometer will display the last
screen that was displayed before the ignition was turned off.
Press "MODE" to change display screens. You can revert back to
the previous screen by pressing and holding "MODE" for 2
seconds.
NOTE: Readings can be displayed in English (U.S.) or Metric.
Refer to Tachometer Calibration.
1. Engine Break-In: Displays the time remaining on the break-in
period of a new engine. This screen will automatically
disappear after the break-in period is complete.
2. Quick Reference Screen: Indicates that the battery, engine
temperature and pressures are operating properly.
3. Temperature: Displays the engine coolant temperature.
4. Power Trim Angle: Displays the trim angle of the outboard or
sterndrive up to the maximum trim angle and then displays the
trailer angle. 0 = down, 10 = maximum trim, and 25 = full trailer.
5. Power Trim Angle/Water Pressure: Displays the trim angle
of the engine and cooling system water pressure.
6. Water Pressure: Displays the cooling system water pressure
at the engine.
To Next Page
Loading...
Need help?
General
