Mercury SC1000 - Simulator Mode

TACHOMETER CALIBRATION
29
Tachometer CAL 1 Calibration - Display Screens
TRIM AND PSI SCREEN ?
[ NO ]
[SAVE] [ YES ]
23788
The split screen showing trim angle and water
pressure is displayed ("YES") or off ("NO").
WATER PSI SCREEN ?
[ NO ]
[SAVE] [ YES ]
23789
The water pressure screen is displayed ("YES")
or off ("NO").
TRIM AND RPM SCREEN ?
[ NO ]
[SAVE] [ YES ]
23979
The split screen showing trim angle and engine
RPM is displayed ("YES") or off ("NO").
RPM SCREEN ?
[ NO ]
[SAVE] [ YES ]
23980
The engine RPM screen is displayed ("YES") or
off ("NO").
FUEL USED SCREEN ?
[ NO ]
[SAVE] [ YES ]
23981
The fuel used screen is displayed ("YES") or off
("NO").
VOLT / HOUR SCREEN ?
[ NO ]
[SAVE] [ YES ]
23982
The split screen showing volts and engine hours
is displayed ("YES") or off ("NO").
SPEED / SEA SCREEN ?
[ NO ]
[SAVE] [ YES ]
23983
The split screen showing speed and sea
temperature is displayed ("YES") or off ("NO").
DEPTH SCREEN ?
[ NO ]
[SAVE] [ YES ]
23984
The depth screen is displayed ("YES") or off
("NO").
[ NO ]
[SAVE] [ YES ]
23547
SIMULATOR MODE
NO
Enables the simulation mode. (Used for
demonstration purposes only).
[ NO ]
[ YES ] [CAL 2]
23549
SIMULATOR MODE
EXIT ?
Press "MODE/SELECT" to exit. Press "-" to go
to the start of CAL 1. Press "+" to continue to
CAL 2.