11. The SmartCraft CONNECT device will connect. Depending on the network strength, this may take a minute.
12. The menu screen will appear. The module will automatically query the Mercury site for any updates to the firmware. If
any updates are needed, there will be an exclamation point in the upper right corner of the Update Firmware tile. In this
event, click on that tile and any updates will begin.
NOTE:The app will say update complete when the module reflash is downloaded to the module. It will then restart, and
may take a few minutes to perform the update. Do not remove battery power during this time.
NOTE:Complete any firmware updates before beginning the configuration process.
NOTE:Wait until the Wi‑Fi LED on the device is solid, or a No Updates ‑ '"Device is not ready to receive a firmware
update". message will appear.
SCC-1 SMARTCRAFT CONNECT GATEWAY INSTALLATION MANUAL
90-8M0219240 eng MAY2023 © 2023 Mercury Marine Page13 / 23
To Next Page
Loading...
Need help?
General
