6
Facility Installation Instructions
(For detailed specifications, see the system specifications of this manual)
Wall-Mount:
Remove wall mount template from packaging.
Place top of the wall mount bracket facing up on wall at desired height and location.
Recommended height is 44” from finished floor to top of wall mounting bracket,
however top of wall mount bracket must be a minimum of 26” above the wall drain.
Trace the 6-hole locations from the wall mount bracket onto wall.
Install the wall mount bracket with fasteners compatible with wall construction at the 6
traced hole locations. Fasteners length and material should be such that fastener is
capable of supporting a 200-pound vertical force each.
Hang the 500EZ onto the wall mount brackets two “Hooks”. Verify the system is level and
securely attached to the wall.
Hook up hot/cold supplies and drain lines. Do not hard pipe to water inlets of the system
– Use flexible hoses supplied with system. Plug in power cord. Install three fresh gallons
of soap per label instructions.
Turn water on and inspect for leaks. Repair as necessary.
Install the 2 ½ gallon container and verify the solutions meter on the display has full bars.
System is now ready for operation.
CAUTION: Do not ground metal chassis during installation or operation.
Consult local and national codes: conformity and compliance to local and national codes is the
responsibility of the installer.
To Next Page
