9
The Hand Cleansing Cycle
Check all water hook-ups to ensure they are open and not leaking. Plug the power cord into an electrical
outlet and verify power on (the display panel, master count, & resettable counter will be illuminated).
The system is ready for hand washing.
Solution will be drawn from the 2 ½ gallon container. As solution is consumed the light bar will indicate
the level of solution in the bottle and will flash when the contain is empty. The display will also tell you
when the solution is empty.
FOLLOWING THIS PROCEDURE WILL ENSURE THE MOST EFFECTIVE WASH IN THE SHORTEST PERIOD
OF TIME
1. To initiate a cycle, stand directly in front of the system and place your hands simultaneously into
the center of each cylinder.
2. The hygiene cycle will automatically start as your hands enter the cylinders. Position your hands
at a depth so the outer most ring of the water spray cover the wrist.
3. The countdown timer will begin to countdown from 12 – 0 and the display will show
“WASHING”.
4. You will receive the most effective wash with the hygiene solution is you relax, center your hands
within the cylinder with your fingers slightly spread.
5. At 6 seconds the system will switch from “WASHING” to “RINSHING”. They cycle is complete.
NOTE: The infrared photo optical sensor will not reset for the next cycle until the hands are removed.
To Next Page
Loading...
