11
WARNING
Remove the hand crank before turn on the power.
7.8 Hand Winding the Stairlift
The hand winding feature should only be used to move the stairlift when there is a
power failure.
1. Turn off the ON/OFF switch.
2. Remove the rubber cover on the left side of the carriage, and then push the brake
lever upward to release the brake if required.
3. Remove the rubber cover next to the key switch. Insert the hand crank onto the
motor spindle.
4. Turn the hand crank counter-clockwise to lower the stairlift.
5. Remove the hand crank and push the brake lever downward to engage the brake if
required.
7.9 RECHARGING THE BATTERY
The charging points are located at top and down of the rail. The stairlift will stop
automatically at these points. The battery recharging will not start if the ON/OFF
switch is turned off.
Down
To Next Page
Loading...