Merlin M2000PE - Input Devices

05/04
15
Accessories
MW30 Converter for either mag stripe (ISO2) or 37-
bit Wiegand readers to connect to the 26 or
30-bit Wiegand input on the M2000PE.
GT/SYSTEM Handheld programmer for connection to
M2000PE, or M200R or M1000R memory
modules.
WINGTSYSTEM Software for a PC to be connected to the
M2000PE.
INT485C Converter from RS485 to RS232. Used to
connect a PC with a serial port to the
M2000PE.
M001 Externally mountable aerial with ground plane
for potential RF performance improvement.
Has 2 m of cable and an MCX connector.
M002 10 metre extension cable for M001, with
MCX connector fitted.
Input devices
Proximity reader Any reader with Wiegand 26 or 30-bit data
output.
Any reader with Wiegand 37-bit output (re-
quires MW30 converter)
Combination device Merlin M842IT (two button keyring remote
control with internal proximity tag)
Merlin M842IT (four button keyring remote
control with internal proximity tag)
Mag-stripe reader Any Wiegand 26 or 30-bit output reader.
Any ISO2 output reader (req. MW30 con-
verter)
Wired keypad Any keypad with Wiegand 26 or 30-bit data
output.
Any keypad with Wiegand 37-bit data output
(requires MW30 converter)
Keyring remote control Merlin M842I (two button)
Merlin M844I (four button)
Wireless keypad Merlin M840 (wall mount, weather resistant)
Wireless wall-switch Merlin H128A (one button)
Merlin H128B (two button)
Merlin H128C (three button)