Merrychef eikon e2 - Page 46

E2 SERVICE MANUAL REV D 09/12
46
Error
Code
Oven
Error/Event
Condition
Description Trigger
Error
Level
System
Response
At oven start up
the QTS senses
that the AC mains
voltage read from
the SRB is out of
the ±10%
“SUPPLY
VOLTAGE (V)
OUT OF
RANGE"
message is
displayed on the
E089
E3, E4, E5
Recommission fail -
Cooling fan(s)
The cooling fan(s)
failed the
recommission test
Pressing the "Red
X" when
"CONFIRM
COOLING FAN IS
RUNNING" is
displayed
N/A
"E089
RECOMMISSIO
N FAIL
COOLING FAN"
message is
displayed in the
E2, E6
Pressing the "Red
X" when
"CONFIRM
COOLING FANS
A
RE RUNNING" is
displayed
"E089
RECOMMISSIO
N FAIL
COOLING
FANS" message
is displayed in
E090 All
Recommission fail -
Convection fan
The convection
fan failed the
recommission test
Pressing the "Red
X" when
"CONFIRM
CONVECTION
FAN IS RUNNING"
is displayed
N/A
"E090
RECOMMISSIO
N FAIL
CONVECTION
FAN" message
is written to the
E091 E3
Recommission fail –
Turn Table
The turn table
failed the
recommission test
Pressing the "Red
X" when "OPEN
DOOR CONFIRM
TURNTABLE IS
ROTATING" is
displayed
N/A
"E091
RECOMMISSIO
N FAIL
TURNTABLE"
message is
written to the
E092
E2, E3, E4, E5
Recommission fail –
Convection Heater
The Convection
Heater failed the
recommission test
Pressing the "Red
X" when "HEATER
TEST IN
PROGRESS" is
displayed
N/A
"E092
RECOMMISSIO
N FAIL
HEATER"
message is
written to the
E6
Recommission fail –
High Convection
Heater
The high
convection heater
failed the
recommission test
Pressing the "Red
X" when "HIGH
HEATER TEST IN
PROGRESS" is
displayed
"E092
RECOMMISSIO
N FAIL HIGH
HEATER"
message is
written to the
E093 All
Recommission fail –
Magnetron(s)
The magnetron(s)
failed the
recommission test
Pressing the "Red
X" when
"MAGNETRON
TEST IN
PROGRESS" is
displayed
"E093
RECOMMISSIO
N FAIL
MAGNETRON"
message is
written to the