14
How to mount the ARGUS
Installing several ARGUS devices:
To ensure complete coverage, position the individual movement
detectors so that their detection areas overlap (Figure %).
Mounting the ARGUS on the ceiling:
Figure &:
To mount on the ceiling, turn the sensor head as follows (change the
direction of rotation when you have turned it as far as the stop):
– Turn the sensor head upwards as far as it will go A.
– Turn the sensor head clockwise as far as it will go B.
– Align the sensor head C:
½
Caution: If not installed correctly, the ARGUS can be damaged by
condensation.
If the ceiling is inclined, always mount the ARGUS with the sphere
facing downwards, so that condensation water can drain.
Mount the ARGUS at an angle of inclination of between 15° and
90°; otherwise, protection type IP 55 is not guaranteed.
Mounting the ARGUS on inner/outer corners or on fixed pipes.
Figure /: You can attach the ARGUS to inner/outer corners or fixed pipes
using the Merten mounting bracket, art. no. 565291/..92/..93. The
connecting cable can be fed into the device from behind through the
mounting bracket.
Mounting the ARGUS in wall connection boxes:
Figure (:
1 In order to lead the connecting cable into the back of the device from
above, attach the four spacers supplied to the wall-mounting bracket.
To Next Page
Loading...