MESI mTABLET ABI - Button Functions

38
DETAILED INSTRUCTIONS
Pressing the top button on the MESI
TUBELESS CUFF UNIT while performing
the ABI measurement will stop the
measurement.
Stop measuring
Measurement
mode
5.6.2.2
Unit is waiting for confirmation from the mTABLET.
Blue
Pairing
Standby
Unit battery is less than 25%, please recharge the
unit as soon as possible.
Red
Battery is fully charged.
Green
Charging
Unit is charging.
Orange
Battery capacity is more than 25%.Green
5.6.1.1
5.6.1.2
5.6.1.3
BUTTON
FUNCTIONS
Standby
Quickly pressing the on button in standby
mode will perform a basic status check of
the MESI TUBELESS CUFF UNIT – green,
more than 25% battery charge, while red
means less than 25% charge is left, and
the module should be charged.
Status check
Pairing mode Holding the button for 4 seconds will put
the module into pairing mode where it
can be connected to the MESI mTABLET
UNIT (for more information look at
Chapter 5.1.5 Pairing).
5.6.2
5.6.2.1
To perform a reset of the MESI TUBELESS
CUFF UNIT press and hold the LED
button for 10 seconds until it changes
colour to red. Unit will be ready to use in
a few seconds.
Resetting the
ABI unit