39
MAINTENANCE
MAINTENANCE
6
The device can be only used on battery power therefore it has to
be ensured that the battery is charged regularly. One battery charge
is enough for approximately 200 measurements.
To charge the battery, place the MESI TUBELESS CUFF UNIT on
the MESI LARGE CHARGING PLATE UNIT. During the charging
process the light on the module will be flashing yellow. Only when
the device is completely charged it will start flashing green. For
more information see chapter 5.5 Multifunctional button.
If the capacity of the battery is significantly decreased after a
certain period of intensive use, the battery is most likely spent, and
it should be replaced. As the device does not contain any parts
which can be replaced by a user, contact your local distributor or
the manufacturer about replacing the battery.
6.1 CHARGING THE BATTERY
6.2 CLEANING INSTRUCTIONS
Read and follow cleaning instructions carefully.
• Before cleaning remove the MESI TUBELESS CUFF UNIT from the
charging station and disconnect the cu from the MESI TUBELESS
CUFF UNIT.
• Use a soft lint-free cloth dampened with a proper cleaning agent
to clean and disinfect the exterior/interior of the unit/.
• With a dry cloth wipe o all residues of the cleaning solution.
• Dry the equipment before next use.
• Recommended cleaning agents:
Cleaning – MESI TUBELESS CUFF UNIT:
Hydrogen peroxide (3%)
Ethanol (70%)
Isopropanol (70%)
Mild soap (diluted)
Ammonia (diluted)
Sodium hypochlorite bleach (diluted)
To Next Page
Loading...
