Meta System DEFCOM 3.1B User Manual

9
DEFCOM 3.1B User Manual
EN
CENTRAL UNIT STATUS LED
DIRECTION
INDICATORS
SIREN
Passive arming Slow  ashing 1 Short  ash 1 BEEP
Arming by remote control Slow  ashing 2 Flashes 2 BEEP
Arming without internal tilt sensor
Slow  ashing Flashes 2 + 1 2 BEEP + 1 BEEP
Arming with active contact Slow  ashing 2 Flashes 2 BEEP + 1 BOOP
Initial immunity phase Fast  ashing
Testing during the initial
immunity phase
Fast  ashing 1 BEEP
Central unit armed Slow  ashing
Alarm cycle Switches o Flashing Sounds
Disarming without alarms Switches o 1 Flash 1 BEEP
Disarming when the
motorcycle’s battery is  at
Switches o 4 BEEP
Disarming when alarms
have been memorised
Switches o brie y
every 6 sec.
1 BEEP + 1 BOOP
Pre-alarm phase Switches o 5 BEEP
Service Mode
Flashing very fast
with ignition key ON
1. NOTIFICATIONS
If various alarms have been triggered, the memory will signal them in a sequence with 3 seconds pauses
and will repeat the sequence every 6 seconds. The memory is reset when the motorcycle is started up
or when the alarm system is armed with the remote control again. NOTE: Using the CARD B9.5 with
KeyLess mode, the alarms memory stay available for one minute also after instrument panel activation.
MEMORISED ALARMS LED SIGNALS
Internal movement sensor 1 Flash
Contacts 2 Flashes
Ignition key sensing 3 Flashes
Tampering with cables or battery 4 Flashes
The DEFCOM 3.1B alarm provides di erent signals (led, siren and  ashing of the vehicle indicators)
according to the di erent commands received from remote control and di erent conditions which it
is, following are reported the main signals. Some acoustic signals from the siren during arming and
disarming the alarm (highlighted in bold) will be emitted only enabling the Buzzer Function, this is
possible changing the product factory set-up during installation (see the paragraph “12. MAIN PRO-
GRAMMABLE FUNCTIONS”).
BUTTON A
BUTTON B
Dear Customer,
the DEFCOM 3.1B alarm has a set-up that allows it to be installed on your vehicle quickly and in
compliance with current regulations, at 12th paragraph of this manual are indicated the possible
operating options and if you desire change the original set-up, you could request the customization
to your installer. The product has been designed for Keyless activation and deactivation pairing the
optional CARD B9.5 that you can require to your installer, the operations in Keyless mode are descri-
bed at 16th paragraph of this manual.
USER MANUAL

Meta System DEFCOM 3.1B Specifications

General

Brand	Meta System
Model	DEFCOM 3.1B
Category	Security System
Language	English