Authorised and signed by:
Developed in Co-operation Between A.W.I.S.A and Australia Chamber of Manufactures
This program is based upon the Safe Work Australia, Code of Practice - Managing Risks of Plant in the Workplace ( WHSA 2011 No10 )
NEW MACHINERY HAZARD IDENTIFICATION, ASSESSMENT & CONTROL
Do not adjust or clean until machine has fully stopped.
Ensure clamp beam is correctly adjusted.
Wear gloves to prevent cuts from sharp material offcuts.
(Recommended for Purchase / Buyer / User)
Keep hands clear of folder blades when clamping.
Secure & support work material.
Body parts should be kept clear of moving parts.
Care must be taken when handling folder blades.
Machine should be installed & checked by a Licensed Electrician.
Keep clear of bending material.
Ensure blade fingers are secured to clamp beam.
All electrical enclosures should only be opened with a tool that is not to be kept with the machine.
Wear hearing protection as required.
Ensure guards are secured properly.
www.machineryhouse.com.au
Isolate power to machine prior to any checks or maintenance.
Plant Safety Program to be read in conjunction with manufactures instructions
To Previous Page
Loading...
Need help?
General
