MetaSystem Metafer - Notes on Warranty; Setup and Operation; Ambient Conditions and Site Selection; Fluorescence Preparation Guidelines

Quick Guide
5
&
Caution: Risk of Ineffective Safety Measures!
If it is determined that protective measures are no longer effective, the device
must be taken out of service and secured against inadvertent operation, to avoid
the risk of injury. Contact MetaSystems or its representative to have the device
repaired.
&
Caution: Build-up of Heat! Risk of Fire
Obstruction of vents may cause a build-up of heat in one of the system compo-
nents. This may cause damage or fire in extreme circumstances. Ensure that the
vents are always kept clear of obstructions (min. distance 15 cm).
Notes on Warranty
All MetaSystems systems are covered by a one-year warranty. The manufacturer and its
representative guarantee that the instrument is free of material or manufacturing defects
upon installation. Any defects must be reported immediately and steps taken to minimize
damage. If such a defect is reported, the manufacturer shall be obliged to correct the fault,
either by repairing the device or by replacing it with a new one, at the manufacturer’s dis-
cretions. No warranty is given for defects caused by normal wear and tear (particularly of
moving parts) and improper use of the device.
The manufacturer shall not be liable for damage caused by misuse, negligence or any other
tampering with the device, particularly the removal or replacement of device components,
or the use of unapproved accessories from other manufacturers. Service and maintenance
may only be carried out by trained personnel of MetaSystems. Improper use or modifica-
tion of the hardware in any manner may void the warranty.
Maintenance and service work is to be carried out only by MetaSystems or individuals au-
thorized by MetaSystems. In the event of a problem with the device, please contact Meta-
Systems or its representative.
Various warranty extensions and/or service contracts for software and hardware are avail-
able on request.
Setup and Operation
Ambient conditions — The ambient conditions as outlined under Technical Data should be
adhered to. Select an installation site which is as temperature-stable as possible.
Fluorescence preparations — When documenting fluorescence preparations, do not expose
the microscope to direct sunlight. This helps minimize the influence of stray light.
Staining / FISH— Although imaging software has some capabilities to enhance difficult spec-
imens, it cannot generally correct or compensate for shortcomings or imperfections caused