Metra Electronics 95-5600 - Double DIN Radio Provision

4
Kit Assembly 95-5600
(Figure A)
(Figure B)
1. Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adapter from Metra or
AXXESS. Re-connect the negative
battery terminal and test the unit for
proper operation.
2. Latch the ISO brackets onto the lip of
the trim bezel radio opening. (Figure A)
3. Slide the aftermarket radio into the trim
bezel. Align the holes in the mounted
ISO brackets with the holes in the radio
and secure with the screws included
with the unit. Snap the Double-DIN
trimplate over the mounted radio.
(Figure. B)
4. Reassemble dash in reverse order
of disassembly.
Double DIN radio provision