4
FINAL ASSEMBLY
1
Locate the factory wiring har-
ness in the dash. Metra recom-
mends using the proper mating
adapter and making the con-
nections as shown. (Isolate and
individually tape off the ends of
any unused wires to prevent
electrical short circuit)
2
Re-connect the negative battery
terminal and test the unit for
proper operation.
3
Snap radio / kit assembly into the
factory radio opening.
A
A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
B
C
D
99-5806
To Next Page
Loading...
