Metronix smartServo BL 4000-C Series - Using the Servo Drive in Jog Mode

5 Enabling the servo drive and selecting the set values
5.2.4 Using the servo drive in jog mode
Parameters/Positioning/Go to destination
Figure 26: "Go to destination" window
If the servo drive is in Positioning mode, the drive can be moved manually by clicking and
holding the arrow buttons. The speed and acceleration of the motion profile can be
configured in the Destination parameters window (see section 6.2 Positioning process on
page 86).
Product manual BL 4000-C Page 68 of 298