Figure 11. Connecting the cable drive control device
NOTE: The location of the driving sockets may vary depending on the model of the machine.
The driving sockets are protected with the cover shown in the figure below:
Figure 12. Driving socket cover
NOTE: Make sure the plug is connected straight and locked with lever (callout (1) in figure
above).
Lokotrack LT-series Driving instructions
12 (22) Copyright
©
Metso 2023. All rights reserved.
Project ID: Plant Code: Plant Unit Code: Document Type: Running No: Revision:
1
Metso Document ID:
D100018832
To Next Page
Loading...
