5. Wait for the engine status indication in the middle of the display to turn from yellow to green and indicate
that the engine is ready to start (see figure below).
Figure 7. Engine ready to start
If the display shows alarms, see instructions from
Troubleshooting
.
6. If any of the emergency stop buttons have been pressed, do the following to reset the system:
a) Reactivate the emergency stop button by pulling or rotating the knob.
b) Switch power off and on again.
7. Check that the machine has enough fuel, especially if you are track driving the machine on a sloped
surface. You can see fuel level from the display main view or the main view pop-up that appears after
initialization.
8. Start the engine by pressing and holding the Engine start/stop button (see figure below). The machine
gives an acoustic warning signal before it starts. Release the Engine start/stop button when the engine is
clearly running. If the engine does not start, see
Troubleshooting
.
Figure 8. Engine start/stop button
9. If alarms are displayed on the control panel display, fix the alarm causes and sign off the alarms. See
Handling alarms
.
DANGER
GENERAL HAZARD
Will cause death or serious injury.
In a dangerous situation, stop the machine with the emergency stop button, the key switch of the
machine, or with the remote stop button (located on either the radio control box or the remote
control box).
1.3 Handling alarms
NOTE: Reading and understanding the alarm messages as well as the using the help information
will help you to understand functions of the machine.
Lokotrack LT-series Driving instructions
Copyright
©
Metso 2023. All rights reserved. 9 (22)
Project ID: Plant Code: Plant Unit Code: Document Type: Running No: Revision:
1
Metso Document ID:
D100018832
To Next Page
Loading...
