Radio control selection switch
(on the main control panel)
Must be in position 0
Manual valve selection switch
(on the main control panel or on
the hydraulic center)
Must be in OFF position
If equipped: conveyor safety
switch (on the hydraulic center
or the main electric center)
Must be in position 1
Only for LT1213(S) and
LT1110(S): crusher
maintenance safety switch (on
the control panel)
Must be in position 1
Figure 5. Position of switches
3. Disconnect the drive control device from its socket if it is connected. Refer to
Figure 11. Connecting the
cable drive control device
.
4. Switch on the power with the key switch (see figure below) on the control panel by turning the key to
position "1". Wait for the control system to finish initialization.
Figure 6. Control panel key switch ON
After initialization, a pop-up with machine information will appear and close automatically after 30
seconds if not closed manually.
Lokotrack LT-series Driving instructions
8 (22) Copyright
©
Metso 2023. All rights reserved.
Project ID: Plant Code: Plant Unit Code: Document Type: Running No: Revision:
1
Metso Document ID:
D100018832
To Next Page
Loading...
