Metso Lokotrack ST2.8 User Manual

Figure 27. Lokotrack ST2.8 battery location
2. If the battery clamps are loose, attach them.
1.12.6 Charging the battery of Lokotrack ST unit
1. If the batteries (24 V
DC
) of the machine need to be charged, locate the battery and remove the + cable
from the battery during charging to avoid damage to the electrical system.
Figure 28. Lokotrack ST2.8 battery location
2. Charge the battery according to the instructions of the battery charger manufacturer.
1.12.7 Charging the battery of radio control device
The operation LED of radio control device indicates the following operational condition and status:
• Continuous green: Transmitter is ON, but not yet operational.
• Flashing green: Transmitter is operational.
• Red light blinking: Low battery
Fast charging:
1. Insert the discharged battery into the battery compartment and snap into place. The charge LED flashes
for 2 seconds, then stays lit.
Lokotrack ST2.8
Driving Instructions
28 (38) Copyright
©
Metso 2023. All rights reserved.
Project ID: Plant Code: Plant Unit Code: Document Type: Running No: Revision:
0
Metso Document ID:
D100014842

Metso Lokotrack ST2.8 Specifications

General

Brand	Metso
Model	Lokotrack ST2.8
Category	Industrial Equipment
Language	English