1 Driving instructions
1 Driving instructions
These driving instructions are valid for Lokotrack ST2.8. The purpose of these instructions is to enable safe
moving of the machine during transportation.
NOTE: Do not use the machine for screening or crushing solely based on these instructions. The
actual instruction manual for the machine is delivered separately.
NOTE: In these driving instructions, it is assumed that the machine is in the transport position. If
needed, see the actual instruction manual of the machine for information on how to prepare the
machine for transportation.
The illustrations in this instruction may not fully correspond to your machine.
1.1 Safety
Because of the size and weight of the machine, pay special attention when moving the machine. It is highly
recommended that a banksman is used when the machine is moved.
DANGER
GENERAL HAZARD
Will cause death or serious injury.
Read the safety section before working with the unit. Only competent and trained personnel are
allowed to work with the unit.
WARNING
PERSONAL INJURY HAZARD
Can cause death or serious injury.
Before starting the machine, make sure that there are no persons in the area whose safety may be
endangered. Walk around the machine and make sure that there is nobody on, by or below the
machine. Warn everybody nearby before starting.
WARNING
CRUSHING HAZARD
Can cause death or serious injury.
Do not drive the machine in locations where there is a risk of squeezing. If possible, drive the
machine either from the feed end or discharge end. Make sure the cable of the drive control device
does not get caught under the tracks.
Lokotrack ST2.8 Driving Instructions
Copyright
©
Metso 2023. All rights reserved. 5 (38)
Project ID: Plant Code: Plant Unit Code: Document Type: Running No: Revision:
0
Metso Document ID:
D100014842
To Next Page
Loading...
Need help?
General
