SECTION 3 - M. FRAME, ADJ. RING, TRAMP REL. & CLRNG JACK ASSY
3-32
MP SERIES CONE CRUSHER TECHNICAL REFERENCE MANUAL
bolts and spacers on the MP1000 and six on
the MP800. Refer to Figure 3-23.
7. Connect the elbow to the hose that runs from
the top of the adjustment ring and up
through the clamp ring. Then connect the
hose between the first cylinder and elbow.
8. Reassemble the dust shell to the adjustment
ring by aligning the matching holes and
installing the lockwashers and attaching
capscrews.
To Next Page
Loading...
