2-6 NORDBERG C SERIES INSTRUCTION MANUAL 140588-2_N EN
CHAPTER 2 - SAFETY
2.2 WARNING SIGNS
The warning signs attached to the equipment must
always be kept readable and clean. Damaged or
loose signs must be replaced at once before starting
the crusher. Make sure that the warning signs are
not covered during installation. If a part of the
crusher attached a warning sign are replaced,
always make sure that the warning signs needed are
included in a new part.
Figure 2.5 The locations of the warning signs
The number and exact locations of the warning
signs may vary according to options (for example,
guards).
The warning signs 1, 2, 3, and 4 are located on both
sides of the crusher.
The warning signs 3 are delivered only if the
crusher delivery includes the drive guards.
The warning sign 5 is delivered only with crushers
that have a mechanical setting adjustment.
The warning signs 6, 7, and 9 are delivered only
with crushers that have a hydraulical setting
adjustment.
IMPORTANT!
There are two different sets of warning
signs depending on the delivery country.
You can check which set of warning
signs is used on your machine from the
side of the machine or the spare part
manual.
IMPORTANT!
Warning signs 1, 2, 3 and 4 are not
attached on crushers installed in
Lokotracks or Nordwheelers.
To Next Page
Loading...
