To Next PageTo Next Page
Need help?Do you have a question about the Metz Mecablitz 40 MZ-3i and is the answer not in the manual?
Lists and describes the different types of AA batteries compatible with the flashgun.
Details the procedure for inserting and removing batteries from the flashgun's compartment.
Step-by-step guide on attaching the flashgun to the camera using its foot or adapter.
Explains the meaning of the flashing battery symbol and its indication of battery status.
Instructions for powering the flashgun on and off using the main switch.
Step-by-step guide for setting up the flashgun in TTL mode for optimal exposure.
Instructions for configuring the flashgun to operate in TTL Easy Mode.
Step-by-step guide for setting up the flashgun in automatic mode for correct exposure.
Step-by-step guide for setting the flashgun to manual mode for full power output.
Explains how to use the secondary reflector for fill-in light during bounce flash photography.
Guidance on performing bounce flash operations in automatic and TTL exposure modes.
Guidance on performing bounce flash operations in manual exposure mode.
Step-by-step guide for setting up and using the flashgun for remote TTL operation.
How to check and verify the slave address for correct remote operation.
Instructions on how to properly turn off the Metz TTL remote operation mode.
Step-by-step guide for setting up and using the flashgun for remote auto operation.
How to use the winder mode with manual flash settings.
How to use the winder mode with automatic or TTL flash settings.
How to adjust partial light output levels when using the flash in auto mode.
How to adjust partial light output levels when using the flash in manual mode.
Explains how adjustable partial light output levels affect flash durations.
Advice on using flash for close-up photography, including parallax compensation.
Step-by-step guide for setting up the flashgun for stroboscopic photography.
How to use fill-in flash in daylight with the flashgun in automatic mode.
How to use fill-in flash in daylight with the flashgun in manual mode.
Achieving full illumination of shadow areas using fill-in flash techniques.
Creating a graduated brightening effect using fill-in flash.
How to use fill-in flash in daylight with the flashgun in TTL mode.
Instructions on how to store custom flash settings into user programs.
How to recall and activate previously stored user programs.
Explains the Ex-Zoom mode for extended coverage, usable with system cameras.
Step-by-step guide for activating and using the Ex-Zoom mode.
How to use the pull-out wide-angle diffuser for broader illumination.
Explains the "Exposure o.k." indicator and how to use test flashes.
Explains the AF measuring beam function for autofocus assistance in low light.
Details the ML function for simulating light conditions and assessing shadows.
How to lock the flashgun's controls to prevent accidental changes.
Explains the Rapid function for faster recycling times between flashes.
Details the automatic cut-out feature to save battery power.
How to adjust exposure in auto mode by changing the aperture.
How to adjust exposure in TTL mode, noting limitations compared to auto mode.
Explains why the display might not show anything when the switch is in the ON position.
Explains potential reasons for flashing operating mode symbols on the LC display.
Procedures to follow if the LC display shows meaningless information or the flashgun malfunctions.
Explains the meaning of a flashing battery warning indicator, indicating exhausted batteries.
General| Power Source | 4 x AA batteries |
|---|---|
| TTL Capability | Yes |
| Modeling Light | No |
| AF Assist | Yes |
| Manual Mode | Yes |
| Guide Number | 40 |
| Zoom Range | 24-105 mm |
| Tilt and Swivel | Yes |
| Compatibility | Canon, Nikon, Sony, Pentax, Olympus, Panasonic |
| Swivel Head | Yes |
| Strobe Mode | Yes |
