Metz mecablitz 64 AF-1 digital User Manual

www.metz-mecatech.de
mecablitz 64 AF-1 digital
für / for Nikon-Digitalkameras incl. CLS-System
Operating Instructions, Bruksanvisning, Käyttöohje,
Brugervejledning, Ekspluatācijas instrukcija
14/38/18

Metz mecablitz 64 AF-1 digital Specifications

General

Brand	Metz
Model	mecablitz 64 AF-1 digital
Category	Camera Flash
Language	English

Summary

1 Safety instructions

3 Preparing the flash unit for use

3.2 Power supply

7 Flash modes

7.1 i-TTL flash mode

Nikon's i-TTL flash metering system.

7.2 i-TTL-BL flash mode

i-TTL Balanced Fill-Flash mode for consistent fill lighting.

7.3 Manual flash mode

Setting manual flash power output.

7.4 Automatic high-speed synchronisation (FP)

Enables flash with shutter speeds faster than sync speed.

7.5 Manual flash mode with distance guideline (GN)

Uses guide number to coordinate flash output with camera f-stops.

7.6 Automatic flash mode

Flash automatically adjusts output based on reflected light.

7.7 Strobe flash mode

Fires multiple flashes in rapid succession for effect.

8 Manual flash exposure correction

9 Special functions

9.1 Motor zoom reflector („Zoom“)

Adjusts reflector position to match lens focal length automatically or manually.

10 Cordless flash mode

10.1 Remote master mode settings

10.1.2 Setting the flash mode on the master flash unit

Setting TTL or Manual mode for the master unit.

10.1.2.1 Setting the exposure correction (EV) in TTL mode on the master flash unit

Adjusting exposure compensation in TTL mode on the master unit.

10.1.2.2 Partial light output in M-mode settings on the master flash unit

Setting manual light output levels for the master unit.

10.1.3 Setting the flash mode for the slave flash unit on the master

Setting flash modes for slave units from the master unit.

10.1.3.1 Set exposure correction (EV) or partial light output for the slave flash unit on the master

Adjusting slave unit settings from the master.

10.2 Remote slave flash mode

10.2.1 Remote slave flash mode settings

Configuring the flash unit as a remote slave.

10.3 Testing remote flash mode

10.4 SERVO mode

10.4.1 Setting SERVO flash mode

Configuring the flash for SERVO mode.

10.4.2 Pre-flash suppression or synchronisation settings

10.4.3 Servo mode partial light output settings

10.4.4 Learn function

10.4.5 Switching-off SERVO flash mode

12 Favorite programme

14 Flash synchronisation

16.3 Factory settings (RESET)

17 Troubleshooting