Meunier Technologies DICE DS

To Next Page

To Previous Page

Pump priming assistance

In order to assist and optimise initial pump

priming, a bleed valve (32) has been integrated

on the left side of the DICE Module. The valve

allows evacuating potential trapped gas between

the pump outlet and the back pressure valve that

could be preventing the pump from priming.

In order to assist pump priming, slightly open the

bleed valve (32) by unscrewing it while the pump

is cycling until fluid starts passing through. Only

partial unscrewing is required. The Bleed valve

does not need to be (and should not be) fully

unscrewed to assist pump priming.

Then simply close the bleed valve and carry on with either the DICE

set-up and

adjustment or the system normal operation.

Note: The bleed valve can also assist with pump priming if the pump loses prime during

normal operation.

Meunier Technologies DICE DS - Page 19