Meunier Technologies DICE DS

To Next Page

To Previous Page

Connections

In order to suit all application needs, a variety of connections are

available. All connections (NPT, Socket, Hose, etc.) are assembled on

the block using the mushroom nut (25). This type of assembly allows

for simple disassembly of connections, thereby avoiding the need to

cut any pipe when doing maintenance.

In order to assemble the pipe with the chosen connection type, slide the mushroom nut

(25) onto the connector (26/27/28). Insert the pipe or flexible hose into the connector

according to state-of-the-art rules so that the two parts are securely fastened to each

other.

The pipes and tubing should be perfectly aligned with the dosing module connections to

prevent mechanical stress. Excessive stress can cause part failure.

Once the assembly is completed, fasten it to the desired port on the block. When

tightening the mushroom nut (25), verify that the o-ring (30) is well positioned in the

connector groove (26/27/28). The mushroom nut (25) should be hand tightened only;

no tools should be used for this. Ensure that the o-ring is properly squeezed.

Connectors: Socket (26), NPT (27), Hose (28), Cap (29)

If an accessory is connected to the accessory port (ex: pulsation damper), it must be

equipped with its own support. The dosing module is not designed to support the

accessory weight.

Note: 25, 26 and 27 are exemplary connectors. All the connector configurations can be

found in the Model Number nomenclature of the IOM (Installation, Operation and

Maintenance Manual).

Meunier Technologies DICE DS - Connections