© Meunier Technologies Inc. 2021 - All rights reserved 36
Pressure indicator and isolator
No periodic maintenance is required on the pressure indicator and its isolator.
If a failure arises related to the pressure indicator or the isolator, the isolator and
pressure indicator assembly (24) should be disassembled from the block (1) and shipped
to the supplier with the RMA form.
The re-installation of the isolator should be done manually (hand
tightened); no tools should be used for tightening.
Note: The pressure indicator and isolator assembly shall not be
disassembled on site. The isolator filling is made by our technician,
using specialized tools, prior to shipment.
Note: Never use a pipe wrench for servicing the dosing modules.
To Next Page
Loading...