Need help?Do you have a question about the Meyer Sound PSW-6 and is the answer not in the manual?
General| Finish | Black textured |
|---|---|
| Audio Input Type | Differential, electronically balanced |
| Audio Input Connector | XLR |
| AC Power Connector | PowerCon |
| Type | Subwoofer |
| Grille | Powder-coated steel |
| Maximum Common Mode Range | ±15 V |
| Input Impedance | 10 kOhms balanced |
| Wiring Pin 1 | Ground |
| Wiring Pin 2 | Signal (+) |
| Wiring Pin 3 | Negative (-) |
Lists operating and environmental parameters for the product.
Method to verify the PSW-6's performance using a microphone and specific distance.
Discusses placement near boundaries and its effect.
Guidelines for creating larger horizontal arrays with more than two cabinets.
Method for setting crossover points between PSW-6 and mid-high cabinets.
Specifies acceptable voltage ranges and behavior during power application.
Explains RMS and peak current for system design and circuit breaker selection.
General safety advice regarding AC power connections and unit handling.
Details the TPL system for power management and driver protection.
Information on using the unit in wet environments and weather protection.
Comprehensive safety guidelines for product installation and use.
Details the rear panel controls and connectors, including optional RMS.
Details the rear user panel with an IEC 309 connector.
To Next Page
