What to do if LED 1 4 flashes and the buzzer beeps on MGE UPS Systems Pulsar Extreme 1500 VA UPS?
If the LED 1 4 flashes and the buzzer beeps on your MGE UPS Systems UPS, it indicates an overload condition where the power drawn by the connected equipment is too high or has been sustained for too long. To resolve this, check the power requirements of your equipment and disconnect any non-essential devices.
Why is LED 1 7 flashing on my MGE UPS Systems Pulsar Extreme 1500 VA?
If LED 1 7 is flashing on your MGE UPS Systems UPS, it means that the ambient temperature is too high (above 40° C). To fix this, move the UPS to a room where the temperature is below 40° C.
How to fix LED 1 4 flashing and buzzer beeping on MGE UPS Systems Pulsar Extreme 1500 VA UPS?
If LED 1 4 flashes and the buzzer beeps on your MGE UPS Systems UPS, it means the overload is too long or too high. Check the power drawn by the equipment and disconnect any non-priority devices.
What to do if LED 1 6 flashes on my MGE UPS Systems Pulsar Extreme 1500 VA?
If LED 1 6 flashes on your MGE UPS Systems UPS, a battery fault was detected during the battery test. Ensure that the battery circuit breaker(s) is closed. If it is, contact the after-sales support department, as the battery is likely faulty.
General| Model | Pulsar Extreme 1500 VA |
|---|---|
| Product Type | UPS |
| Capacity | 1500 VA |
| Output Power | 900 W |
| Frequency | 50/60 Hz |
| Battery Type | Sealed Lead Acid |
| Input Connection | IEC 320 C14 |
| Topology | Line-Interactive |
| Form Factor | Tower |
| Output Waveform | Sine Wave |
| Communication Ports | USB, Serial |
| Output Voltage | 230 V |
| Battery Backup Time | Varies by load |
| Battery Recharge Time | 8 hours |
| Number of Outlets | 8 x IEC 320 C13 |
To Next Page