We would like to thank you for trusting us and buying our product. Before starting the motor, we advise you to read these
instructions carefully, to be sure that the M.G.M. motor is used in safe conditions and to obtain its highest performance.
For the different MGM motors types we suggest to download the “Use and maintenance” in its last and complete version
directly from our web site: www.mgmrestop.com. Should any difficulty arise, please contact the M.G.M. organization,
specifying the type of product and its serial number.
These instructions are valid for all M.G.M. electric motors belonging to the BA series (BA, BAF, BAPV, BAMP, BAE,
BASV). The BA series includes asynchronous three-phase or single-phase totally enclosed fan cooled brake motors.
The motors brake in case of power supply failure. The BA motors series are used as components in industrial
applications. Performance and characteristics shown on the motor nameplate are guaranteed for installations in
ambients having a temperature range of –15°C to +40°C and at an altitude less than 1000 meters above sea level. For
any clarifications, please contact the M.G.M. motori elettrici S.p.A. organization.
The motor shows on its nameplate the CE mark to attest the conformity of the product to the 2006/95/CE “Low voltage”
directive and 2004/108/CE “Electromagnetic compatibility” directive
During operation, motors have live or moving parts. Therefore, removal of electrical or mechanical
guards, improper use, or inadequate maintenance may cause serious damage to persons or
property.
Installation, Maintenance, Adjustment, Replacement operations of components must be carried
out by qualified personnel, using proper tools and working instruments. Above all, it is essential to
verify that motor or plant are disconnected from the supply line and that on board terminals there
is no voltage left.
In case of uneffective braking during regulation, maintenance or replacement operations of
components, check that no load is applied to the drive shaft.
Avoid contact with the motor case since the temperature under normal operating conditions may
exceed 50°C
When receiving the motor, it is essential to check that:
- all the characteristics shown on the motor nameplate correspond to the requested ones;
- the motor has not been damaged during transportation; any damage must be pointed out to the carrier immediately.
The ringbolts, if any must be used to lift only the motor without any other machines fitted to it.
The motors must be stored in a sheltered, dry and dust-free place.
The installation of the motor must be carried out by qualified personnel, using proper tools and working instruments.
When the installation is started, be sure that the characteristics expected from the motor match what is shown on the
motor nameplate, whith particular attention to the supply voltage and to the maximum braking torque.
Make sure that the braking torque shown is suitable for the desired application.
Please verify that the type of brake is suitable for the application and in compliance with standards
or rules in force on the machine on which the motor is incorporated.
Verify that for the application requirements is need to be used a motor of ˆK or ˆPK series (e.g. lifting,
safety applications, cranes and so on). For further details pls contact MGM motori elettrici SpA.
CE Mark
General safety information
Receipt and Storage
Installation
ENGLISH
To Next Page
Loading...