Copyright © 2009-2018 Micca. All rights reserved. 180201
To replace the battery in the remote, place the remote control face down, press down on
the ridged area of the battery cover and pull towards you to remove the tray. Place one
CR2025 lithium button-cell battery on the tray with the positive “+” side facing you.
Reinsert the tray.
4 Getting Started
4.1 Initial Setup
Find a flat and stable surface to place the photo frame. Swing out the built in stand fully
to prop up the photo frame – make sure the stand is fully extended or else it will
collapse during use. Plug the AC adapter into a standard 110V AC or 240V AC
electrical outlet and connect it to the DC Power Input on the photo frame. If the frame
turns on and displays the main menu, proceed to the following steps:
Carefully remove the protective film covering the LCD.
Remove the plastic battery insulator from the battery compartment and make sure
the remote control has a battery inside.
Press the “Power” button on the remote control to turn the player on or off.
Your digital photo frame is now ready for use.
To Next Page
Loading...
