Miccus Home RTX 2.0 - Miccus RTX 2.0 Advanced Features; Optical Audio Pass Through Explained; Factory Reset Procedure; Miccus RTX 2.0 Troubleshooting

LIGHT FUNCTION
LED Blue (CH1 & CH2)
LED Green (3.5mm & Opcal)
LED blinks blue rapidly Pairing mode
LED solid green Opcal or 3.5mm Connected
CH 1 and CH 2 blue LED o,
3.5mm or opcal green
Standby Mode (no pairing detected)
LED blue stays on
Connected with either the SBC or
aptX codecs
LED blue stays on with 2
blinks every 5 seconds
Connected with the aptX Low
Latency codec
OpcalPassThrough
The Miccus Home RTX 2.0 features digital audio pass through. Digital
audio coming into the Home RTX 2.0 via the “Opcal In” will also pass
through to the “Opcal output.” Most televisions and stereo systems
feature only one opcal audio output. The Home RTX 2.0 allows the user
to receive an opcal audio feed from a television or stereo system and
transmit/stream that audio feed to two pair of headphones or Bluetooth
speakers simultaneously. The Home RTX 2.0 can then pass that same
audio onto a soundbar, stereo receiver, or another Miccus Home RTX 2.0
without the use of an opcal audio splier. Use the same audio source
and daisy chain two or more Miccus® Home RTX 2.0’s together; double
or even triple the number of low latency audio streams available for use.
Factory Reset
If for any reason the Home RTX 2.0 is not working as expected, clear
the memory and restore default sengs to the Home RTX 2.0.
• Ensure the Home RTX 2.0 is connected to USB power.
9
• Press and hold the mul-funcon buon for roughly 10 seconds
unl the unit powers o.
• Once powered o, memory has been cleared and the unit has
returned to its factory default sengs.
• When powered back on, the Home RTX 2.0 will enter pairing
mode directly.
FAQandTroubleshoong
PROBLEM SOLUTION
Miccus Home RTX 2.0
does not turn on
1. Check the USB power connecon
2. Make sure to press and hold the
power buon for 5 seconds.
Audio breaks up or
wireless range is
too low
1. Make sure the antenna is aached
securely and posioned correctly.
2. Move the Miccus Home RTX 2.0 away
from other 2.4 GHz equipment such
as Wi-Fi routers and microwaves.
No sound/audio
output
1. Check the cables to make sure they
are connected to the correct jacks.
2. Press play on your music source.
3. Check to make sure your volume is
set to a listenable level.
Can’t control Volume 1. By design the Miccus Home RTX 2.0 is
a passive transmier or receiver and
has no volume control. User volume
level must be adjusted via the input
and/or output sources connected to
the Miccus Home RTX 2.0.
10