EasyTouch RV
14
©2023 Micro-Air LLC Revision 1.2
My appliance is not running long enough to affect the inside temperature. What can be done?
The length of an appliance cycle can be adjusted to run longer or shorter using the Hysteresis setting. This
will put more or less energy into the space per cycle, respectively.
You can use the FAQ My inside temperature does not seem to be accurate. What is going on? to see if the
reason is an inaccurate reading from the temperature sensor.
Why is my electric fan continuing to run or constantly running?
Why is the A/C always running or running in furnace mode?
EasyTouch RV often runs the electric fan at the end of a cycle to harvest remaining energy in the appliance
after it has shut off. Some EasyTouch RV models bring this as an improvement over the old system and is
normal operation.
If the fan never shuts off then make sure you have the fan speed set as you expect. Manual fan speed
selections will constantly run the fan. Use the Fan Operation (Electric) section to verify how yours is set.
If you think the A/C is running, it may just be the electric fan running so make sure the fan is set as expected.
What is my thermostat’s software revision?
What is my thermostat’s serial number?
What model EasyTouch RV do I have?
The software revision is the numbers separated by 3 dots. The serial number is the 9-digit number. The
EasyTouch Model number is the first three digits of the serial number.
I have (1 to 4) zones in my old system, but EasyTouch RV has a different count.
I am missing some zones that I had in the old thermostat.
Zoned systems use digital communication to a control board and have some signal wires associated with
them. First, check if there are no faults displaying by using FAQ There is text at the top-center of the main
screen. What does it mean? Come back here if there are no faults or stop and handle them appropriately.
Then, initiate a scan for the missing zones using the factory reset button, or the rescan button if available.
To Next Page
Loading...
