EasyTouch RV
15
©2023 Micro-Air LLC Revision 1.2
I do not see modes that I should have. Where are they?
Where is my furnace mode?
Why do I only have a white fan for a mode?
Use the Common Thermostat Operations section for how to use the available modes in normal operation.
Some systems automatically detect what modes are available by talking to the A/C control board and
displays them appropriately. Other systems do not and must be configured at the thermostat. Use the
EasyTouch RV Reference Manuals for your model to see if your thermostat must be manually configured and
verify it is done properly, using its Installation and Setup sections. If the thermostat is fine and only the app
is missing modes then see the FAQ The thermostat has all my modes but the app does not?.
Not all systems or zones have all modes. Whatever you have with EasyTouch should/must match the original.
Where is my Aqua mode (hydronic heat)?
For all EasyTouch RV models except the 350 model, “furnace” mode and “aqua” mode are identical. It is
simply a cosmetic difference. The image can be changed to make more sense for your system. For the 350,
it is important to set this appropriately.
My thermostat screen is blank, but I can control it from the app. Tapping the screen does nothing.
Sometimes, electrical noise may get into the screen and corrupt it. Try removing power to the thermostat by
opening/disconnecting the 12VDC breaker/fuse for a few seconds. Restore power and check the operation.
If tapping the screen wakes it up then it is likely set for Night mode (How do I turn off the backlight so that
the screen is completely dark?) and is normal operation.
App Operation
How do I change my units in the app (Fahrenheit/Celsius)?
To Next Page
Loading...
