MicroBT WhatsMiner M3 - Default Chapter; Table of Contents

Contents
1. Operational safety warning
.........................................................................................................
3
1.1. Matters needing attention of the miner's wiring
............................................................
3
1.1.1. Control board 12V power cable connection precautions
.....................................
3
1.1.2. Connection of power control cable
......................................................................
4
1.1.3. Fan cable connection check
..................................................................................
4
1.1.4. Data cable connection check
................................................................................
5
1.1.5. Connect the power cable of the hash board
........................................................
5
1.1.6. Final check
.............................................................................................................
6
1.2. Notes for handling of the miner
.......................................................................................
7
2. Preparation of miner configuration
............................................................................................
7
2.1. List of miner configuration tools
......................................................................................
7
2.2. Reference network diagram of miner
..............................................................................
8
3. Miner data configuration (configuration on webpage)
..............................................................
8
4.1. Query the dynamic IP address obtained by the miner
....................................................
8
4.1.1. Run the WhatsMinerTools software
.....................................................................
8
4.1.2. Check the IP address of the miner.
.......................................................................
9
4.2. Configure static ip (optional)
.........................................................................................
10
4.3. Configure NTP server address and mine pool & miner data.
........................................
12
4.3.1. Modify NTP synchronization server address (optional)
......................................
12
4.3.2. Mine pools & miner configuration.
.....................................................................
13
5. Check the running status of the miner
.....................................................................................
15
6. Configure miner in batches, check status, upgrade firmware
..................................................
18