In the Set up menu, select "Language" with the cursor and
press ENTER.
Choose “English” with the ▼ ▲ keys and press Enter.
If you want to esc programming and return to measurement,
press the ESC button for 3 seconds.
MEASURE
The choice of the “Measure” is the second setting to do after the choice of “Language”.
To change the default measurement (pH) and switch to
Rx:
In the Set up menu, select with the cursor the submenu
"Measure" and press ENTER.
Use the ▼ ▲ keys to select pH or RX measure and press
ENTER.
If you want to esc programming and return to
measurement, press the ESC button for 3 seconds.
PASSWORD
The password protects the modification of the Dosage, Utility and Relay menus.
It does not block Calibration and Set up.
First definition of the password:
In the Set up menu, select "Password" by the cursor and
press ENTER.
Enter the password digit by digit selecting the number by ▼
▲ button and pressing ENTER.
After the selection of the 4th digit, press ENTER to save the
password. Take note of it carefully to not forget it. If it is not
possible to remember the password call the Customer
Service Assistance.
To esc programming and return to measurement, press the
ESC button for 3 seconds.
In the Set up menu, select "Password" by the cursor and
press ENTER.
Enter the old password digit by digit selecting the digit by ▼
▲ buttons and press ENTER.
After entering the 4th digit, pressing ENTER it is possible to
define the new password.
Enter the new password digit by digit selecting the digit by ▼
▲ buttons and press ENTER.
After entering the 4th digit, press ENTER to save the new
password.
Take note of it carefully to not forget it. If it is not possible to
remember it, call the Customer Service Assistance.
If you want to esc the programming and return to
measurement, press the ESC button for 3 seconds.
To Next Page
Loading...
Need help?
General
