Need help?Do you have a question about the MICRODOS MP2- PH/RX and is the answer not in the manual?
General| Brand | MICRODOS |
|---|---|
| Model | MP2- PH/RX |
| Category | Measuring Instruments |
| Language | English |
Details the layout and function of the device's front panel buttons and indicators.
Lists the core operational capabilities and features of the MP2-HT PH/RX pump.
Details various connectors including power, enable, probes, sensors, and alarm outputs.
Lists default parameter values and outlines the procedure to restore factory settings.
Illustrates screen displays for Manual, Proportional, and ON-OFF dosing modes.
Details standby activation, pump priming, and level probe alarm handling.
Guide to navigating menus, including Set Up for language, measure, and password.
Details on Dosing types, probe calibration, and Utility functions like Delay On and TAL.
Configuration options for the alarm relay and its response to various alarm types.
Procedure to change the pump's interface language to English, French, or Spanish.
How to select between pH or Rx as the primary measurement type.
Steps for setting up and changing the pump's access password.
Configure the external input for dosing consent, including activation and status.
Manage the broken hose sensor, including its alarm function and input activation.
Setting the time delay (0-99 min) before dosing starts after power-on or flow alarm.
Configuring the Time Alarm based on accumulated dosing units.
Procedure to reset programming and calibration parameters to factory defaults.
Managing flow sensor operation and setting its type (N.O./N.C.).
Configuring PT100 probe input or manual temperature setting.
Configuring relay output modes and selecting alarm types for signal activation.
Setting the relay's contact mode (Normally Open/Closed) and choosing alarm signal inclusion.
Choosing between Manual, Proportional, and ON-OFF dosing methods.
Setting a constant flow rate for manual dosing operations.
Setting Setpoint, Threshold, Flowrate, and Delay On for proportional pH dosing.
Setting Set Off, Set On, Flowrate, and Delay On for ON-OFF pH dosing.
Procedure for calibrating the pH probe's offset and gain using buffer solutions.
Setting Setpoint, Threshold, Flowrate, and Delay On for proportional Rx dosing.
Setting Set Off, Set On, Flowrate, and Delay On for ON-OFF Rx dosing.
Procedure for calibrating the Rx probe's offset using a buffer solution.
To Next Page
