EasyManuals Logo

Microlife Aponorm Basis Control User Manual

Microlife Aponorm Basis Control
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
8
18
-D or
18
-E. In this case re-position the cuff
and repeat the measurement. For other error
messages, please read chapter 7 on page 12
.
4. Once the correct pressure is reached, the
inflating stops and the pressure gradually falls.
If the required pressure was not reached, the
monitor will automatically pump some more
air into the cuff until the blood pressure can be
taken.
5. During the measurement, the “pulse rate mea-
surement active” icon
17
flashes in the display.
6. The result, comprising the systolic
11
and the
diastolic
12
blood pressures and the pulse rate
per minute
13
is displayed.
7. When the monitor has finished measuring,
remove the cuff.
8. Switch off the monitor. (The monitor does
switch off automatically after approx. 1 minute,
though).
You can stop the measurement at any time
by pressing the On/Off button (e.g. if you feel
uneasy or an unpleasant pressure sensation).
This monitor is specially tested for use in
pregnancy and preeclampsia. When you detect
unusually high readings in pregnancy, take your
blood pressure again after a short while (approx.
1 hour). If the reading is still too high in the
repeat measurement, please contact your doctor
or gynaecologist.
Manual inflation
In case of very high systolic blood pressure (e. g.
exceeding 135 mmHg), it can be of use that you
determine the pressure yourself. Press the On/
off button after the monitor started inflating and
a pressure of approx. 30 mmHg appears in the
display. Keep the button pressed until the pressure
is about 40 mmHg above your average systolic
value – then release the button.
How not to store a reading
As soon as the result appears in the display, press
the on/off button
1
and keep it pressed until «M»
16
is flashing. Confirm the deletion by pressing the
time button
4
.
«CL» is shown after the reading was successful-
ly deleted from the memory.
How do I evaluate my blood pressure?
The triangle at the left edge of the display
15
points at the range your blood pressure reading is
in. The reading is either in the optimum (white),
increased (cross-hatched in grey) or high (black)
blood pressure range. The classification corres-

Other manuals for Microlife Aponorm Basis Control

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Microlife Aponorm Basis Control and is the answer not in the manual?

Microlife Aponorm Basis Control Specifications

General IconGeneral
BrandMicrolife
ModelAponorm Basis Control
CategoryBlood Pressure Monitor
LanguageEnglish

Related product manuals