Saving readings stored on your monitor (iOS):
•
Open the Microlife Connected Health App
•
Select the profile which you would like to upload.
Once selected, the profile will be highlighted, and
check mark will appear to its left.
•
On your blood pressure monitor: Press and hold the
power button for 8 seconds. Once connected, a
Bluetooth® icon will appear on the blood pressure
monitor’s screen.
•
Follow steps 4 & 5 in “saving measurements
manually”
5.3 Android OS Phones
Setting up your phone:
•
In the settings menu, turn Bluetooth® “ON”
•
Select the Microlife Connected Health App
•
Select “User Profile”
•
Select “+” at the top of the screen to create a new
user profile.
•
Review the terms of service, and select “Accept”
to proceed.
•
Enter your information and select the check mark
to confirm.
On your blood pressure monitor:
•
Confirm the correct user is selected on your blood
pressure monitor. The user icon on the top left
hand side of the monitor screen should be set to
your preference - 1 or 2).
•
Press and hold the “START/STOP” button on the
monitor for 8 seconds until the Bluetooth® icon
flashes.
•
To change users on your monitor, see section 3.8.
To Next Page
Loading...
