Micronta 22-214A - REPLACEMENT OF BATTERY;FUSE; To Install or Replace the Battery or Fuse

REPLACEMENT OF
BATTERY/FUSE
WARNING: TO AVOID ELECTRIC SHOCK, DISCONNECT
THE TEST LEADS BEFORE REMOVING THE BATTERY OR
FUSE, REPLACE ONLY WITH THE SAME TYPE BATTERY
OR FUSE. OPEN THE CABINET ONLY WHEN REPLACING
THE BATTERY OR FUSE. DO NOT TOUCH ANY AREA
INSIDE THE CASE OTHER THAN BATTERY OR FUSE.
CAUTION: FOR CONTINUED PROTECTION AGAINST FIRE,
REPLACE ONLY WITH 0.75A, 250V FUSE SUCH AS OUR
CAT. NO. 270-1272.
Note: The fuse will blow when voltage is applied when
tester is in OHMS range, or current range (except 10A
range), on when excess voltage is applied to 0.25 DCV/
0.125DCV range. When the fuse blows, there will be
no deflection of meter.
28
To install or replace the battery or fuse: Replacement of Battery/Fuse
1. Disconnect the test leads.
2. Open the cabinet by loosening three screws on the back.
3. Replace the battery if necessary.
Install one 9 V battery such as our Cat.Nos.23-583/553 and
one AA 1.5V penlight battery such as our Cat. Nos. 23-582/
552. Observe correct polarity.