Micronta 22-214A - GOOD METER MEASUREMENT PRACTICES

—
Replacement of Battery/Fuse
4. If the fuse has blown, remove it.
5. Insert a new fuse, using only one of the same
type/rating (0.75A, 250V/Cat. No. 270-1272). One spare
fuse is supplied with your Multitester inside the cabinet.
6. Close the cabinet and replace the screws.
WARNING: DO NOT OPERATE THE UNIT UNTIL THE
CABINET IS FULLY CLOSED.
30
GOOD METER MEAS-
UREMENT PRACTICES
Here are some good general rules that apply to the use of
electrical meters. Some are common-sense; others are
important safety precautions.
1. There is always the possibility of dangerous voltages
being present in any piece of electrical/electronic
equipment. Always use extreme caution when making
measurements - high voltage may appear at unexpected
points in a suspected defective circuit.
2. Never attempt to measure voltage or current above the
specified maximum the Multitester is designed for; the
maximum input limit for voltage and current measurement
between @) V-9-A and © COM is 1000V AC, 250V DC
and 500mA DC.
3. Exercise extreme caution when measuring voltages of
150V and above.
of eee, Me
*. f2
se Mt OF es
ee cae
EXTREME CAUTT
Gen MAKING MEASURE MAY
31